Installation
Instructions

Installation Guide for the RGB SLOTCOVER

 

Step 1: Preparation

Make sure that your computer is powered off and disconnected from the power supply before starting the installation.

 

Step 2: Locate the Free Slots

Find the free PCIe slots in your computer case where you want to install the RGB slot covers and remove the existing slot covers from your case.

 

Step 3: Installing the RGB Slotcover

Carefully slide the RGB Slotcover into the free PCIe slots. The slot position can be chosen freely, depending on which location is most suitable for routing the cable. Make sure the RGB Slotcover are securely seated in the slot and then fasten them with screws.

 

Step 4: Connecting the RGB Slotcover Together

Connect the RGB Slotcover to each other using the included JST 2mm 3-pin cables. Ensure that all connections are secure and firmly attached.

 

Step 5: Connecting to Power / Control

Use the included JST 2mm 3-pin to standard ARGB 3-pin 5V cable and connect it to the appropriate ARGB 3-pin 5V header on your motherboard or to an external ARGB 3-pin 5V controller to establish the connection. Make sure the connection is secure.

 

Step 6: Powering On the Computer

Turn on your computer and check whether the RGB Slotcover are functioning properly. Use the included remote control of your external RGB controller or any RGB software supported by your motherboard to customize colors and effects according to your preferences.